用好打膠機你就要知道哪些事
一般情況下，要能夠正確使用打膠機，一方面可以做出好的產品，另一方面也可以延長打膠機的使用壽命，保持打膠機的性能穩定持久，下面
雙組份打膠機廠家為您簡單說明一下。
In general, you should be able to use the glue dispenser correctly. On the one hand, you can make good products, on the other hand, you can extend the service life of the glue dispenser, and keep the performance of the glue dispenser stable and lasting. The two-component glue dispenser manufacturer will give you a brief explanation.
1.由于雙組份密封膠的固化需要一定的時間，已涂覆雙組份密封膠的玻璃應緩慢水平移動。
1. As the curing of two-component sealant requires a certain time, the glass coated with two-component sealant shall slowly move horizontally.
2.A組和B組膠水應保持清潔，防止異物進入膠水。
2. Group A and Group B glue shall be kept clean to prevent foreign matters from entering the glue.
3.在連續工作過程中，膠槍每次停止工作一般不應超過20分鐘，否則用A組份膠將混合的膠全部沖出，直到從槍口排出一根A組份膠為止。
3. In the process of continuous operation, the glue gun shall not be stopped for more than 20 minutes each time, or the mixed glue shall be flushed out with component A glue until a component A glue is discharged from the gun mouth.
4.嚴禁強行擠壓或彎曲高壓軟管，以免影響系統的正常運行。
4. It is forbidden to forcibly squeeze or bend the high-pressure hose to avoid affecting the normal operation of the system.
5.混膠機應始終保持暢通，以保證良好的出膠效果。如有堵塞，可在丙酮中浸泡后清洗。建議每5組清洗一次。
5. The glue mixer shall always be kept unblocked to ensure good glue discharging effect. If there is blockage, it can be cleaned after soaking in acetone. It is recommended to wash every 5 groups.
6.當膠槍長時間不使用(超過一周)時，應將膠槍本體拆下，用溶劑清洗膠槍和混膠機內的殘余膠。
6. When the glue gun is not used for a long time (more than a week), the glue gun body should be removed, and the residual glue in the glue gun and the glue mixer should be cleaned with solvent.
7.不同的雙組份膠水廠家生產的膠水中雜質的量是不同的。根據實際情況，b組過濾器和單向止回閥通暢。建議每兩組清洗一次。
7. The amount of impurities in the glue produced by different two-component glue manufacturers is different. According to the actual situation, group b filters and one-way check valves are smooth. It is recommended to wash every two groups.
8.因膠水凝固而引起的膠槍、管道或整機故障，不保修。
8. There is no warranty for the failure of glue gun, pipe or complete machine caused by the solidification of glue.
9.定期對各油泵加油口進行加油，確保注油器中有連續的油。
9. Fill the oil filler of each oil pump regularly to ensure that there is continuous oil in the oil injector.
此外使用打膠機前，確保電源電壓穩定，電路，確保機器開機時正常運行。打膠機工作時，檢查周圍的人是否保持距離，以免機器工作時傷及附近的人。關注我們
http://dejiansw.cn，了解更多事項！
In addition, before using the glue applicator, ensure that the power supply voltage is stable, the circuit is safe, and the machine can operate normally when it is started. When the glue applicator is working, check whether the people around it keep a safe distance to avoid injuring the people nearby when the machine is working. Follow us http://dejiansw.cn , learn more!
上一篇：如何做雙組份打膠機的日常的維護工作
下一篇：是否選購打膠機您可以從兩方面思考
