全自動涂膠機在涂膠時出現問題的原因！
全自動涂膠機在涂膠時出現混合攪拌器無法旋轉的原因以及具體的解決方法。以下幾個方面是上根據長期的涂膠經驗，總結出的幾項導致混合攪拌器無法正常旋轉的原因：
The reason why the mixer can't rotate in the automatic gluing machine and the specific solution are presented. The following aspects are the reasons why Shanghai Shanjia can't rotate the mixer properly according to its long-term experience in gluing.
1、混合電機220V電源未開。
1. The 220V power supply of the hybrid motor is not turned on.
2、混合電機線路有損壞或松動。
2. Hybrid motor lines are damaged or loosened.
3、攪拌器或軸承有卡死
3. Stirrer or bearing stuck
4、伺服驅動器菜單未在顯示PC模式。
4. Servo driver menu is not showing PC mode.
具體的解決方法：
Specific solutions:
1、打開混合電機驅動器的220V電源開關
1. Turn on 220V power switch of hybrid motor driver
2、檢查混合電機的線路，插好混合電機的電源前后端接口
2. Check the circuit of the hybrid motor and plug in the front-end and back-end interface of the hybrid motor.
3、檢查混合室是否干凈，混合槍軸承有損壞需要更換
3. Check whether the mixing chamber is clean or not. If the bearing of the mixing gun is damaged, it needs to be replaced.
4、關掉電源重新啟動機械（重啟后還未顯示PC模式檢查電機線路接頭前段和后端和控制系統的那端
4. Turn off the power supply and restart the machine (PC mode is not displayed after restart to check the front and back end of the motor line connection and the end of the control system).
上一篇：密封膠對于打膠機的重要性！
下一篇：自動打膠機不為人知的小功用！
